Grade 12 results are out. Where to check yours

Grade 11 Physics unit 6

Capacitance: C = Q/V, and what the plates decide

4 min · 2 past exam questions worked through

Parts of the lesson

Tap a part to play the lesson from there.

A 4-minute Temari video lesson on Grade 11 Physics unit 6: Capacitance: C = Q/V, and what the plates decide. Free to watch, no account needed.

More on unit 6

The chapter's own page holds the rest of what Temari has on it, such as short notes and practice questions with their answers.

Open the unit 6 page

Everything the lesson says

The lesson's words, part by part. Tap a time to play the lesson from there.

0:00Introduction

A capacitor is a small device that stores electric charge. How much charge it can hold for each volt is called its capacitance. Two formulas answer almost every exam question on it, and today you will use both.

0:14A capacitor

A capacitor is two conductors placed close to each other, but not touching. It is a device that stores electric charge, and so electric energy.

0:25Capacitance

To charge it, one plate is connected to the positive terminal of a battery, and the other to the negative terminal. One plate ends up with a charge plus Q, the other with minus Q.

The charge stored is proportional to the potential difference between the plates. So Q equals C times V, and the capacitance is C equals Q over V. Its unit is the farad. Small capacitances are measured in microfarads: one microfarad is ten to the minus six farads.

0:58Exam question 1Past exam

Now a real exam question, from the 2016 Grade 12 national exam. It tests this Grade 11 chapter. A capacitor stores twenty microcoulombs when the potential difference across its plates is two hundred volts. What is its capacitance? Pause the video, and try it.

Use C equals Q over V. Twenty microcoulombs is twenty times ten to the minus six coulombs. Divide by two hundred volts: 0.1 times ten to the minus six farads. The answer is C. Always write micro as ten to the minus six before you divide. B is the trap: ten is two hundred over twenty, V over Q, upside down. And A is ten times too big.

1:53The plates decide C

Capacitance does not depend on Q or V. It depends on the capacitor itself: the size of the plates, the distance between them, and the medium between them. For two parallel plates of area A, a distance d apart, in a vacuum, C equals epsilon nought times A, over d.

So bigger plates give a bigger capacitance, and a bigger gap gives a smaller one. Put a dielectric, an insulator such as glass or plastic, between the plates, and the formula gains a factor k, the dielectric constant. k is greater than one, so a dielectric always increases the capacitance.

2:36Exam question 2Past exam

One more, from the 2007 national exam. A parallel plate capacitor has a capacitance of ten microfarads. The distance between the plates is doubled, and nothing else changes. What is the new capacitance? Pause, and try it.

The gap d sits at the bottom of the formula. Double d, and C is cut in half. Half of ten microfarads is five. The answer is B. D is the trap: it doubles the capacitance, when the gap is what doubled. And C forgets that the gap matters at all.

3:17Summary

So remember. Capacitance is the charge stored for each volt: C equals Q over V. For parallel plates, a bigger area raises C, a bigger gap lowers it, and a dielectric always raises it. Keep practising questions like these on Temari.et.

Practise this unit in the app

Temari turns this chapter into timed practice and marks it as you go, with an AI tutor to explain anything that did not land.

Start free

Temari.et is also an Android app, free on Google Play.

Sign inCreate your account